Auma Part-turn gearboxes GS 50.3 - 250.3, primary reduc Manuel d'utilisateur télécharger pdf (Page 15)

Setting end position OPEN

Remove all bolts (03) at limit stop housing (10) (figures F, G).

Change to manual drive and move the valve manually to end position OPEN.

In case limit stop housing (10) has not yet rotated, turn it counterclockwise up to

the stop.

Turn limit stop housing (10) back by ½ turn clockwise. This ensures that the

mechanical end stop is not reached in electric operation.

If the holes of limit stop housing (10) do not correspond to the threads of the

housing (1), take off the limit stop housing (10) and replace it in the required

position.

Fasten bolts (03) with lock washers (04).

Fasten bolts crosswise with a torque according to table 3.

If the position of the pointer cover does not align with the symbol OPEN, slightly

loosen the screws of the pointer cover. Turn the pointer cover to the OPEN

symbol and fasten the screws again.

Switching off in end position

OPEN

Turn back the valve from the end position by an amount equal to the overrun.

Set limit switching according to the operation instructions SA/SAR.

Setting end position

CLOSED

The end stop need not be set since the required swing angle has been set in the

factory.

Move gearbox to the end stop in position CLOSED.

The last part of the travel has to be made manually.

To turn the valve back manually from the end position by an amount equal to the

overrun, proceed as follows:

For actuators mounted directly:

by approx. 4 to 6 turns at the handwheel.

With mounted primary reduction gearing VZ/GZ:

by approx. 10 to 15 turns at the handwheel, according to the reduction ratio of

the primary reduction gearing.

Set limit switching in actuator for the end position CLOSED according to the

operation instructions SA/SAR.

If the swing angle does not match, refer to section 10.

Operation instructions Worm gearboxes GS 50.3 – GS 250.3

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Pas de commentaire

Auma Part-turn gearboxes GS 50.3 - 250.3, primary reduc Manuel d'utilisateur Page 15